Owner manual

ULTRA-CUT 100 XT
Manual0-5272 OPERATION 4-7
GCM 2010 Gas Control Module: Controls & Indicators
1. MODE Selection Switch
MODE
RUN
SET PREFLOW
SET PLASMA
& SHIELD
TEST
PREFLOW
H
2 O
MIST
PLASMA
SHIELD
PRESSURE
PLASMA
POWER SUPPLY
GAS
FLOW
High Precision
Plasma Cutting System
ENABLE
DISABLE
GAS
MODE
RUN
SET PREFLOW
SET PLASMA
& SHIELD
TEST
O2 - AIR
O2 - O2
H35 -N
2
F5 - N 2
AIR - AIR
N
2 -
H
2
O
N
2 - N 2
Art # A-04765_AB
9
9
GCM
2010
• NormallyintheRUNpositionduringtorchoperation.
• IntheSETPREFLOWposition,PreoworPilotinggas(AirorN
2
)owstothetorchallowingtheoperatorto
adjustpressure.Gasautomaticallyshutsoffafter2minutesifleftintheSETPREFLOWposition.
• IntheSETPLASMA&SHIELDposition,selectedcuttinggases,Plasma&Shield,owtothetorchtoallow
operatortosetthepressure(regulator&gauge)andow(knobattopofowmeter).Gasesautomatically
shutoffafter2minutesifleftintheSETPLASMA&SHIELDposition.GCM2010gascontrolrevisionAGor
later includes inlet pressure sensors. In SET PLASMA & SHIELD position the LCD display shows alternately
the plasma an shield inlet pressure. If either gas pressure is outside the acceptable range, the display shows
“PSIlow(orhigh),theactualpressureandthelimititisbelow(orabove).
• IntheTESTposition,selectedcuttinggasses,Plasma&Shield,alsoowtothetorch.ThePlasmaoutletpres-
sure (pressure going to the torch), is displayed.
• ForGCM2010gascontrolrevisionAGorlatertheModeSelectionSwitchincludesahiddenfunctionusedat
initialsetuptocongurethegascontrolforthegasleadlength.SeeSequenceofOperation,initialsetup.