Owner manual

ULTRA-CUT 100 XT
Manual 0-5272 INSTALLATION 3-39
Install the V-D Board.
1. Locate the V-D Board which should be with the iCNC.
2. InsidethePowerSupply,locateandremovethemountingpanel’s2screwsandpanel.
3. InstalltheV�DboardstandoffsandtheV�DBoardfromtheXTiCNCthenreattachthepanelwiththe2screws,
securing the V-D board in place. If using another V-D Board, follow the instructions provided mounting it
in this same location.
Space for V-D Board Ohmic clip cable port
V-D Board connection
V-D Board installed
Art # A-12079
V�DBoardshownwithoptionalwireharnessforiHCcontroller
Control Cable.
TheiHCboardcanbesuppliedwithawireharnessandconnector(showninpreviousimage),tobeinstalledin
therearpanelholelabeled“HeightControl”.TheconnectormateswithacablefromtheiHC.Forotherheight
controlV�Dboardsastrainreliefcanbeinstalledinthisholeforthosecables.RefertoAppendixforwiringdiagram.