Owner manual

ULTRA-CUT 100 XT
3-28 INSTALLATION Manual 0-5272
2. Refertoillustration.ConnectthePilotwireandNegativecablesusingastarwasheroneach.
NOTE
* Slave and Master refer to only those set ups using two power supplies in parrallel. Slave is not used in single
system operations.
*Negative (Master)
Torch Lead
Pilot
Art # A-12063_AB
*Negative (Slave)
Negative Master, Negative Slave and Pilot Cables (from Power Supply )
Art # A-12064
Control Cable from Power Supply rear panel