Owner manual

ULTRA-CUT 100 XT
Manual 0-5272 INSTALLATION 3-25
3.18 Install Remote Arc Starter
Site Location
Select a clean, dry location with good ventilation and adequate working space around all components.
Reviewthesafetyprecautionsinthefrontofthismanualtobesurethatthelocationmeetsallsafetyrequirements.
Interconnecting cables and hoses attach to the Arc Starter. There must be adequate space around the Arc Starter for
theseconnectionswithoutexcessivekinkingorbending.
Mounting Dimensions
NOTE
Height not shown is 7.375” ( 187mm )
38.10mm
1.50in
190.50mm
7.50in
50.80mm
2.00in
203.20mm
8.00in
50.80mm
2.00in
38.10mm
1.50in
Art # A-12058
Installation
TheRemoteArcStartermustbeinstalledinasuitablelocationnearthetorchhead. If the Arc Starter is mounted
toagantryortoanyothersupportsubjecttomotionorvibration,fastentheArcStartertothesupportsecurely.
1. Loosen,butdonotremove,thelowerscrewssecuringthecovertotheArcStarter.Removetheupperscrews
securing the Cover Panel to the Arc Starter.
NOTE
A ground wire connects the cover to the Arc Starter base. This wire must remain in place.