Owner manual

ULTRA-CUT 100 XT

3�24 INSTALLATION Manual 0-5272

NOTE

Ensure the four coolant lines described below are connected and leak free before connecting power to J71.

Matchthecolorsofthehosestothefrontpanellabel.Supplylinesaregreenandreturnlinesarered.Facingthe

unitasshownbelow,theleftconnectionsgototheUltra�CutXT™powersupply,therightconnectionsgotothe

RAS1000arcstarter.

CAUTION

Do NOT cross the coolant lines as this will not provide cooling for the XT™ plasma torch as designed and void

the warranty.

Attachandtightenall#6JICttingswith11/16”(18mm)wrench.Donotovertightenasitwillstripthetting

threadsandwillcausealeak.DonotstarttheUltra�CutXT™withoutcoolantinthereservoir.Anadditionalgal-

lon(3.78l)ofcoolantisrequiredtocompensatefortheHE400beingattachedtothesystem.Monitortheuidlevel

whilellingtheUltra�CutXT.Donotallowthecoolantreservoirleveltodropbelowminimum.

Attach the J71 cable after the Cooler and coolant lines have been determined to be leak free.

Art # A-09624_AB

UnderlowpowerplasmacuttingtheHE400maynotcomeon.Thisisnormaloperation.

Periodically check obstructions in the radiator and remove them by vacuuming the ﬁns. Do not use cleaners or

ﬂuids to remove debris, they may affect the radiator integrity.