Owner manual

ULTRA-CUT 100 XT
3-� INSTALLATION Manual 0-5272
3.07 Connect Work Cable and Pilot and Negative Leads
1. Removetheoutputpowercovertotheleftofthecoolantlterattherearofthepowersupply.Todothis
remove the two screws then lift up and pull away.
2. Routetheendsoftheworkcable,pilotandnegative/torchleadsupwardthroughtheleadsstrainreliefat
the bottom edge of the left rear panel.
3. Refertotheillustration.Connecttheleadsasshown.Tightensecurely.Donotovertighten.
Art # A-11533
Pilot
Work Cable
Torch
+
-
4. Reinstallthecoveronthepowersupply.Snugthehardwaresecurelybyhand.Donotovertighten.