Owner manual

ULTRA-CUT 100 XT
Manual 0-5272 APPENDIX A-11
5
OK to Move2 –ProvidesasecondsetofN.O.contactsthatclosewhenarctransferisdetected.Contactsarerated
formaximumof24VAC/DC@1A.SimpliedCNCCircuit.
5
+10V @ 10ma. For Remote CC Pot–PreviouslyCCMversionsifonewantedtouseapotentiometerfortheRemote
Analog Current Control (CC) input an external 10 V supply was required for Pot High.. Now an isolated (from main
plasmacircuits)10Vsupplyisprovided.Recommendedvalueofthepotis5Kor10K.
Ext. +10V
11
10
9
TB1
+10V
WIPER
Art # A-09246
5
Plasma Marking Select (Remote)–PlasmaMarking,availableonlywithDFC3000,maybeactivatedwithacon-
tactclosurebetweenTB3-1&TB3-2ifSW8-4,DIPswitchontheCPUboard(smallerofthe2CCMboards),isalso
on. Opening the connection between TB3-1 & TB3-2 switched back to normal cutting mode. For Ultracut power
suppliesItisOKtoleaveSW8-4onwhetheryouaremarkingornot.
The following functions may not yet be available on your system. *
*Corner Current Reduction (input)---Whenactivated,normallyfromatablecontroller’scornerorheightcontrol
inhibitsignal,signalingthatthecuttingspeedisbeingreducedtonavigateacornerorsmallradius,thecutting
currentisreducedataxedratetoapredeterminedleveltoprovideanimprovedcutatthelowerspeed.
*Cut Expanded Metal (input)---Normally the plasma supply is optimized for pierce cutting, high pierce height
directlyabovethemetaltobecut,shortpilottime,etc.Activatingthisinputadjuststheplasmasupplytooptimize
it’sparametersforcuttingexpandedmetal,perforatedmetal,runningedgestarting,etc.Amongotherchangesthe
transferheightisreducedtosameascutheight.InadditiontoactivatingtheCutExpandedMetalinputCCMswitch
SW1-1shouldbeturnedonautomaticallyrestartthepilotandSW8-1setonforlongerpilottime.
*Spare contacts --- .