Manual

ULTRA-CUT 100 XT
4-24 OPERATION Manual 0-5303
CCM Status Code
Group 6 -- CCM
Code Message Remedy / Comments
601 Analog Voltage Error Defective CCM, replace.
602 ADC or DAC error Defective CCM, replace.
603 Reserved Noinformationavailable;Contactcustomerservice
604 Data Memory error Defective CCM, replace.
605 Program memory fault Defective CCM, replace.
606 +5V Logic supply low Defective CCM, replace.
607 Processor over temperature Reduceambienttemperature;DefectiveCCM;replace
608
5V supply for RS 485/422 com-
munication low.
Defective CCM, replace.
609 Firmware Update Device Error DefectiveCCM;replace
610 Firmware Update Protocol Error DefectiveCCM;replace
611 USB Controller Fault DefectiveCCM;replace
612
USB Power Fault
FaultyUSBdevicepluggedintoUSBport,remove;DefectiveCCM
613
USB Log Creation Fault
Unable to create Log file on USB Flash drive last firmware update at-
tempt;UsedifferentUSBFlashDriveorReformat
614
No USF File
FileVTCCMFW.USFmissingfromFlashDrive;AddproperlestoFlash
DriveforFirmwareUpdate;UsedifferentUSBFlashDriveorReformat
615
No CCM Update File
CCMFirmwarelespeciedinVTCCMFW.USFnotfound;Addproper
files to Flash Drive for Firmware updating
616
DPC Update Fault
FaultoccurredattemptingtoupdateDPCrmware;Addproperlesto
USBFlashdriveforFirmwareupdating;RefertoCCM_LOG.TXTonFlash
Drive for details
617
DMC Update Fault
FaultoccurredattemptingtoupdateDMCrmware;Addproperlesto
USBFlashdriveforFirmwareupdating;RefertoCCM_LOG.TXTonFlash
Drive for details
618 ADC Calibration Fault ErrortoolargecalibratingADC;FaultpersistsdefectiveCCM;
619 Flow Switch Fault Flowswitchreportingcoolantowwhenpumpoff;
620
Non Volatile Memory Error
NonVolatileMemoryStorageCorruptedandErased;Faultpersists
defective CCM.
4.12 DMC-3000 Status Codes
Status Code indicators:
1. At power up, RED & GREEN indicators flash program firmware revision number in a 2 digit code as ex-
plained below. Following the revision code
2. Green indicator
· On steady = OK, communication established.
· Blinking = no communication established with CCM
3. Red indicator
· Off = Status OK
· Rapid blinking = downloading new program
· Blinking 2 digit code = Status (table below)