Manual

ULTRA-CUT 100 XT
Manual 0-5303 INSTALLATION 3-33
Installation
The Remote Arc Starter must be installed in a suitable location near the torch head. If the Arc Starter is mounted
toagantryortoanyothersupportsubjecttomotionorvibration,fastentheArcStartertothesupportsecurely.
1. Loosen,butdonotremove,thelowerscrewssecuringthecovertotheArcStarter.Removetheupperscrews
securing the Cover Panel to the Arc Starter.
NOTE
A ground wire connects the cover to the Arc Starter base. This wire must remain in place.
2. Remove the Cover Panel from the Arc Starter.
Art # A-12059
Lower screws
(2 per side)
Upper screws (2 per side)
Cover
Ground Wire
Cover Removal
3. Position the Arc Starter on a at, horizontal mounting surface.
4. Use pre-drilled holes in at least two of the feet on the bottom of the Arc Starter to secure the Arc Starter to
the mounting surface.
Art # A-12060
Minimum 2