Manual

ULTRA-CUT 100 XT

A-80 APPENDIX Manual 0-5303

613 USB Log File Creation Fault

When updating the CCM, DMC and DPC programs from a ﬂash drive, a log ﬁle called CCM_LOG.TXT is cre-

ated on the ﬂash which reports on the results of the update including any problems. If that log ﬁle can’t be

created you get 613. This may be a problem with the ﬂash drive having too many other ﬁles on it or a problem

with its format that may not be compatible with the CCM.

1. Try putting the update les on a different, preferably empty, ash drive.

2. Or save all the ash drive les in another place on your computer, then delete all the les on the ash drive.

Now copy onto the ash drive only the les required for program updates.

3. If the above doesn’t work, making sure you still have copies of the les, format your ash drive which erases

everything on it. Now load only the les required for program update.

614 No USF File

The ﬁle VTCCMFW.USF is required on the ﬂash drive along with the program ﬁles when performing a program

update. If it’s either missing or corrupted the display will show b614. The “b” indicates the fault is generated

by the Bootloader program rather than the normal application program code. Note that each new revision of

the program ﬁles is supplied with a new VTCCMFW.USF. Even though the name is the same it requires the

new version of this ﬁle that is supplied with the application code.

1. Install the correct VTCCMFW.USF on the ash drive.

2. If you already have the correct version of VTCCMFW.USF perhaps the ash drive is the problem. Follow

the instructions for code 613.

615-617 No Update File for CCM, DPC or DMC found

Program ﬁles for the CCM, DMC & DPC may be updated through the plasma supply’s USB port. The GCM2010

is updated by other means. For a unit with GCM 2010 the CCM may still be updated using the USB. Program

update ﬁles are in the format Cx_x_0.S (CCM); Mx_x_0.S (DMC) and Px_x_0.S (DPC).

If the Bootloader ﬁnds there are 3 devices, CCM, DMC & DPC on the CANBUS but the ﬂash drive doesn’t have

all 3 update ﬁles it will go ahead and update those it has but will show a code indicating that one or more are

missing (615 for CCM; 616 for DMC; 617 for DPC).

Try another ﬂash drive or if you know this one is OK (it works with a computer), then replace the CCM.

This completes the Advanced Troubleshooting information.