User Manual

16 Multi Format LCD Monitor Multi Format LCD Monitor 17
[4] GPI / UMD [4] GPI / UMD
• Momitor ID
- Sets the ID of each monitor for the TV Logic
control protocol or DYNAMIC UMD using RS-
422/485 communication.
- Available values are between 0, 1, 2 ~ 125.
• UMD Display
- This item sets UMD, ANC and DYNAMIC UMD.
- Available modes are O, UMD, ANC, D-UMD
(S-8C), D-UMD(S-16C) and D-UMD(D-8C).
* UMD : Displays user customized characters
on screen.
* ANC: Displays characters embedded in SDI
signal.
* D-UMD(S-8C) : Displays incoming data of 8
characters and tally signal from TSL protocol
(V3.1).
* D-UMD(S-16C) : Displays incoming data of 16
characters and tally signal from TSL protocol
(V3.1).
* D-UMD(D-8C) : Displays incoming data of two
pairs of 8 character strings and tally signals
from TSL protocol (V3.1).
• D-UMD TALLY TYPE
- Tally type conguration setting in D-UMD(D-
8C), UMD Display.
- Conguration values are DEFAULT, USER
COLOR, CHARCTER, BG .COLOR, USER TALLY,
USER CHAR and USER BG.
• TALLY1 COLOR / TALLY2 COLOR / TALLY3
COLOR / TALLY4 COLOR
- Used to set the color of each TALLY 1, TALLY 2,
TALLY 3 and TALLY 4.
- Available colors are RED, GREEN and YELLOW.
• B0:0 B1:0 ~ B0:1 B1:0
- The item sets the color of input condition for
byte0, byte1 in TSL Protocol Control Byte.
- The selectable colors are OFF, WHITE, RED,
GREEN, BLUE, YELLOW, CYAN, MAGENTA.
• UMD Character
- Customizes the characters for Under Monitor
Display.
- Alphabets, numbers and special symbols are
available.
- Maximum of 8 characters are available.
• UMD CHARACTER COLOR
- Used to set the color of UMD character.
- Available colors are WHITE, RED, GREEN,
BLUE, YELLOW, CYAN and MAGENTA.
- Activates whe the [D-UMD Tally type] sets
following modes : [Default], [User Color], [BG.
Color], [User Tally] or [User B.G.]
• UMD BG. TRANS
- Used to set the transparency of the UMD
background.
- Available values are SCALE DOWN, OPAQUE,
50%, 90% and 100%.
• UMD FONT SIZE
- This function adjusts the size of UMD FONT.
- Available modes are SMALL and LARGE.
• XLR TALLY On/O
- Used to set Tally operation according to the
input level of TALLY IN terminal which is
among the terminals of XLR 4P connector in
the rear.
• XLR TALLY Operating Level
- Used to set the input level of Tally operation.
(Open&Low : less than 0.6V, High : more than
2.5V)
- High: Set the level as “High” to activate the
Tally and set the level as “Low” to inactivate
the Tally.
- Low: Set the level as “Low” to activate the Tally
and set the level as “High” to inactivate the
Tally.
• XLR TALLY Color
- Used to set Tally color.
- Available colors are Red and Green.
5. Menu Operations 5. Menu Operations