User Manual

36 Multi Format LCD Monitor Multi Format LCD Monitor 37
[10] Internal Pattern
<Color Bar + Pluge Pattern>
<Gray Pattern>
[1] SOFTWARE UPGRADE
8. Firmware Upgrade
• USB memory stick(Thumb drive) that has
F/W is necessary.
• Select Display&Set menu
- Connect USB memory stick to USB slot in
front of the monitor.
- Set [S/W upgrade] as [On].
- If USB memory stick is connected correctly,
[S/W upgrade start] is activated.
* if the item is not activated, please disconnect
and connect the USB memory stick again.
After 5 sec. do the same procedure.
- Select [Yes] in [S/W upgrade start] and
proceed the rmware update.
* During the update, the monitor screen is o,
and nothing functions.
* After the update, TVLogic logo shows up on
the screen, and the monitor initializes.
* Update can take 10~20min. depending on
rmware kind.
- The monitor searchs USB memory stick.
[10]
HDMI To SDI Conversion-Out
Input (HDMI) Output(SDI)
480 59.94i/p
576 50i/p
480i(59.94)(SMPTE-125M)
576i(50) (ITU-R BT656)
7. Other Functions
• Video source from ‘HDMI input’ terminal
can be output through ‘SDI throughout’
terminal.
※ Note: HDSLR camera manufacturers usually
specify the resolution and frame rate for the
recording. The signal format that is output
through HDMI terminal of cameras may dier
from makers to makers. The signal format for
HDMI output and playback function of Canon
HDSLRs is 59.94i. And even though 60i or 60p
is specied in the specication of the cameras,
the actual recording or HDMI output format
would be 59.94i or 59.94p.
• SDI Input formats are output as below :
• In HDMI Color format, RGB mode is not
available.
• Displays internally generated test patterns.
- The pattern consists of ColorBar and Pluge+
Grayscale Patterns. Full screen colors of
various gray levels(0~100%) are also
embedded.