User Manual

26 Multi Format LCD Monitor Multi Format LCD Monitor 27
[2] SDI Button
[3] HDMI Button
[7] Display & Set
5. Menu Operations
• Key Led Indication
- The item turns on / o LED in front of the
monitor.
- Even though you turn o KEY LED, when you
press LED button in front of the monitor, the
LED is on and after 3 sec. the LED is o.
• S/W upgrade
- Firmware-updates with USB memory stick
(Thumb drive).
• S/W upgrade start
- When S/W upgrade is [On], the monitor detects
USB memory stick, and update is available, it is
activated.
6. Button Functions
[1] Analog Button
2. Use [UP]/[DOWN] Knob to select desired
input source, then enter to conrm.
3. Input signal resolution displays on the
bottom of OSD menu.
4. Press ANALOG button again to remove the
OSD menu from display.
5. Menu will be disappeared when time set is
over from the screen.
• This product is capable of processing all
input signals usable in ANALOG mode.
• The Analog input settings are as follows:
1. Press the ANALOG button on the front of the
product and activate the menu below :
• LVM-075A unit is capable of processing
dual SDI Input signal.
1. Press [SDI] button on the front of the
monitor and activate the OSD menu as
shown on the below.
2. Input resolution displays on the bottom of
the OSD screen.
3. Press [SDI] button again to remove the OSD
menu from display.
# If no image displays after selecting the
desired input mode, check and make sure that
your connection is not lose or disconnected.
• LVM-075A unit is capable of processing
Single HDMI Input signal.
1. Press [HDMI] button on the front of the
monitor and activate the OSD menu as shown
on the below.
2. Input resolution displays on the bottom of
the OSD screen.
3. Press [HDMI] button again to remove the
OSD menu from display.
# If no image displays after selecting the
desired input mode, check and make sure that
your connection is not lose or disconnected.