User's Manual

FHD Viewnder Monitor 25
• DEFAULT
- Used to initialize OSD values to factory default.
- Available modes are DEFALUT and FACTORY.
- In the DEFALUT mode, except for the stored
3D LUT, all values are initialized.
- In the FACTORY mode, all values are initialized
to factory default.
• LUMINANCE
- Used to indicate the current Luminance value .
- In the case of System Default, the value returns
to factory default(after color calibration).
- Available values are from 0 to 50.
• INTERNAL PAT (INTERNAL PATTERN)
- Generates ColorBar, Pludge and Grayscale
Pattern internally.
- Selectable range for Gray Pattern is from 0% to
100% with 5% increment.
* See section “7. Other Function -> [12] Internal
Pattern” for more information.
• DISPLAY ENABLE
- Used to set the LUMINANCE to the minimum
value when the time set in the still image
output is exceeded.
- When video is output or the MENU button is
pressed, the LUMINANCE is reset to the
original value.
- Settable options are ON, 5MIN, 10MIN, 20MIN
and 30MIN.
- In the Function Key, the screen can be turned
ON/OFF immediately by user’s choice.
• FAST MODE
- Used to minimize the de-interlacing processing
time delay and improves the quality of fast
moving and ne details under interlaced
format.
- Since the function of this feature is to minimize
the de-interlacing delay, it will not be eective
under progressive format.
- Feature bypasses deinterlacer, playing back
2 full elds per frame. Also reduces signal
processing delay for reduced audio/video
delay.
• ECO SAVING
- Used to save power consumption automatically
when there is no monitor signal.
- When the signal is supplied, the brightness of
the monitor will be changed to the set value.
• EXTERNAL FAN
- Connect the FAN to the USB port of the monitor
and set the ‘EXTERNAL FAN’ mode to ‘FAN ON’.
(Can also be set in Function Key).
- Press the button of the FAN to adjust the wind
speed.
- OFF : The LED indicator light up in red and the
FAN turns o. When powering on the FAN for
the rst time, it is set to OFF mode.
- FAST : The LED indicator light up in green and
the FAN operates at high speed.
- SLOW : The LED indicator light up in orange
and the FAN operates at slow speed.
* When using ‘Calibration’ or ‘USB Upgrade’ via
the USB port, set it to ‘EXTERNAL FAN OFF’ in
the OSD menu.
• S/W UPGRADE
- Used to upgrade the rmware using USB
(Thumb drive).
* See section “7. Other Functions -> [13]
Firmware Upgrade” for more information.
• VERSION
- Displays current rmware version.
• SERIAL NUM
- Displays the serial number of the monitor.
[7] SYSTEM
5. Menu Operations
SYSTEM F-5A
DEFAULT
LUMINANCE
INTERNAL PAT
DISPLAY ENABLE
ECO SAVING
FAST MODE
EXTERNAL FAN
SW UPGRADE
VERSION
SERIAL NUM
OFF
OFF
ON
ON
OFF
OFF
OFF
SW 00 FPGA 00 BOARD 00
12345678
+ 48