Installation Guide

8 CB66 - CB67 - CB68 Operator’s manual
3.1 Type of Programme (Programme Type)
The machine allows the choice between eight different Programme Types of Balancing Programmes as
listed in table T3.1
Table T3.1 - Programme Types available
Programme
type
Wheel
material
Weight position along
the rim section
Automatic
acquisition
(1)
Notes
STD Steel Default 2 sensors Start-up default
ALU1 Aluminium Default 2 sensors
Forcibly set when the
Motorbike Programme
Type is selected.
ALU2 Aluminium Default 2 sensors
ALU3 Aluminium Default 2 sensors
ALU4 Aluminium Default 2 sensors
ALU5 Aluminium Default 2 sensors
ALS1 Aluminium
Default for the internal
weight, provided by the
user for the external
weight
1 sensor
ALS2 Aluminium Provided by the user 1 sensor
(1) Available only for some versions
Programmes are selected in the NORMAL mode by pressing the buttons [P4]
or [P5] .
At the fi rst selection of one of these two buttons, the currently selected Programme Type will appear on the
display; if within about 1.5 seconds, one of these two buttons is not pressed again, the display will return
to the previous state without editing the running Programme Type.
Depending on the running Programme Type, the following LEDs are lit on the control panel:
• Programme type LED See fi gure F1, detail [7].
• Weight Imbalance Position LED. See fi gure F1, detail [13].
Note:
The selection of the STD Programme Type removes the selection of the Static imbalance display.
The selected Programme Type also infl uences the automatic acquisition of wheel dimensions (feature
available only on some models of the machine) as shown in the Automatic acquisition column in table
T3.1. The acquisition that features only 1 sensor uses the Distance/Diameter sensor.