Installation Guide

6 CB66 - CB67 - CB68 Operator’s manual
2. MACHINE START-UP - DIAGNOSTICS
Once the machine is started, it runs the actions shown in diagram below.
Diagram - Programme fl ow at machine start-up
START-UP
YES
NO
NO
NO
YES
YES
View the programme name on the left display.
View auxiliary message if necessary.
Machine is ready to operate.
View default data.
View the programme release on the right display.
Switch on all LEDs.
Shut-down all electric loads.
Switch on acoustic signal.
Wait two seconds.
Switch on the illuminator.
Switch on the electroma-
gnetic clamping brake.
View error code
Err 015 follo-
wed by the code
of the pressed key.
View error code
Err 016 “dis
out”
View error code
Err 021
Release all keys
then switch off
and then on again
Restore the distan-
ce sensor in the
rest position or
press F+P2
Press any key to
continue, then
enter Calibration
for the CAR/SUV
Wheel Type and/
or calibration for
the MOTO Wheel
Type.
Electric
loads
= available only on some models
Pressed
keys on the
keypad?
Distance sensor in
the rest position?
Machine
calibrated?





