Installation Guide

CB66 - CB67 - CB68 Operator's manual 5

The keys [P8] Start and [P10] Stop have different effects depending on the position of the

wheel guard as indicated in table T1b.

Table T1b - Effects of the Start and Stop keys in relation to the state of the wheel guard

Button pressed Wheel guard position Result

[P8] Start

HIGH

• if the clamping brake is disabled, the machine will not

run the launch and emits three beeps meaning that the

requested action is not possible;

• if the position brake is enabled and imbalances are displa-

yed, the machine will run the launch at low speed (SWI

procedure. See chapter 8.5 SWI wheel stop procedure on

the positions of imbalance)

NOTE: for operator safety purposes, the SWI procedure will

not be run when the MOTO Wheel Type is active.

LOW The machine will run the balancing or testing launch

[P10] Stop

HIGH No action.

LOW

• No action if the wheel is spinning;

• Spinning stops if this is in progress

1.2 NORMAL, SERVICE, STAND-BY operating modes

The machine features three operating modes:

• NORMAL mode. This mode is enabled when the machine is switched on and allows the use of the machine

to run wheel balancing;

• SERVICE mode. In this mode, there are a number of utility programmes available to enter settings (e.g.

unit of measure in grams or ounces) or controls for machine operation (such as calibration).

• STAND-BY mode. After 5 minutes of inactivity, the machine automatically switches to the STAND-BY mode

to reduce power consumption. The green STBY LED present on the control panel ﬂ ashes to indicate that

the machine is in this mode. To exit the STAND-BY mode, press any button (with the exception of [P7]

). All data and settings are maintained in the STAND-BY mode. In SERVICE mode, the machine will

not switch to the STAND-BY mode.