Installation Guide

44 CB66 - CB67 - CB68 Operator’s manual
10. SIGNALS
10.1 Error codes
The machine reports error conditions by showing an error code on the display. The list of the error codes
is shown in table T10.1.
Table T10.1 – Error codes
Error code Description Notes
000 to 009 Machine parameters Contact technical support.
010 Reverse rotation of the wheel Contact technical support.
011 Wheel speed too low
Check the mains voltage. If the checks do not lead
to any results, contact technical support.
012
The wheel cannot be stopped at the
end of the launch
Check the mains voltage. If the checks do not lead
to any results, contact technical support.
013 Wheel speed too high Contact technical support.
014 The wheel does not spin Contact technical support.
015 Keys pressed or jammed at start-up
Release all buttons, then turn off or restart the ma-
chine. If the error persists, contact technical support.
016
Distance sensor not in rest position
when the machine is switched on
Set the sensor to its rest position: the error should
disappear. If the error persists, contact technical
support.
017
Width sensor not in rest position
when the machine is switched on
Set the sensor to its rest position: the error should
disappear. If the error persists, contact technical
support.
018 Reserved
019 Communication processor failure
Turn the machine off or on. If the error persists,
contact technical support.
The machine can still be used but all functions
related to the USB port are disabled.
020
Lack of communication with the
eeprom memory
Turn the machine off and then on again. If the error
persists, contact technical support.
021
Lack of machine calibration data or
incorrect calibration data
Carry out calibration for the CAR/SUV Wheel Type
and/or for the MOTO Wheel Type. If the error persists,
contact technical support.
See also ERR030 and ERR031 .
022 Pick-up channel A too high
Excessive imbalance or anomaly. Turn the machine
off and then on again. If the error persists, contact
technical support.
023 Pick-up channel B too high
Excessive imbalance or anomaly. Turn the machine
off and then on again. If the error persists, contact
technical support.
024 Internal timer channel too high
Excessive imbalance or anomaly. Turn the machine
off and then on again. If the error persists, contact
technical support.