Installation Guide

CB66 - CB67 - CB68 Operator's manual 41

Fig. F9.2 Selection of the Lead balancing weights

9.10 [F+P3] Exit the SERVICE mode

This button allows the machine to exit the SERVICE mode and return to the NORMAL mode.

9.11 [F+P4] Read launch number counter

By pressing this button, the total number of balancing launches run by the machine will be displayed. The

number of launches is shown on both displays. Figure F9.3 shows as an example of a machine’s display

that has run 1,234 balancing launches.

Fig. F9.3 - Display of the number of the balancing launches

Balancing launches that were interrupted are not included in the total count of balancing launches (for

example, those stopped by pressing [P10] Stop

or those interrupted by raising the wheel guard)

and all those run in the SERVICE mode.

9.12 [F+P5] MENU Parameters

The Menu parameter is reserved for the technical support personnel and therefore is not described in this

manual. Access to this menu is protected by password.

9.13 [F+P6] USB port

This button is not currently used in Service mode. By pressing this button, the writing Usb will appear on

the display for one second.

9.14 [F+P9] MENU Test Programmes

This menu allows running tests for some machine functions. The Menu has the following options:

• Enc Encoder disc test;

• RPM Number of shaft RPMs test;

• SIG Pick-up signals test;

• dPy Display test.

• tAS Keypad test;

• UFc Converter voltage-frequency test.

• Ret Returns to the Service mode

To scroll through the different menu options, press [P4]

or [P5] until the desired