Installation Guide

40 CB66 - CB67 - CB68 Operator’s manual
9.3 [P3] Machine calibration
This button allows accessing the machine’s calibration procedure as described in detail in chapter 4 Machine
calibration.
9.4 [P4] Select grams/ounces
By pressing this button, the machine alternates the unit of measure of the wheel weight: if the unit of
measure selected is in grams, select ounces and vice versa. This selection is maintained even when the
machine is shut-down.
The unit of measurement selected will be displayed for one second.
9.5 [P5] Select inches/millimetres
By pressing this button, the machine alternates the unit of measure of the wheel dimensions: if the unit
of measure selected is in inches, select mm and vice versa. This selection is maintained even when the
machine is shut-down.
The unit of measurement selected will be displayed for one second.
9.6 [P6] Select the imbalances view threshold
This button allows editing the imbalances view threshold. This procedure is intended for technical support
personnel and is not described in this manual.
9.7 [P9] Not used
This button is not currently used in Service mode.
9.8 [F+P1] Not used
This button is not currently used in Service mode.
9.9 [F+P2] Select weight material in Fe/Zn, or Pb
Use this button to select the balancing weight material. The options available are listed in table T9.1. The
selection of the material type slightly changes the balancing results because the weights in Iron/Zinc are
lighter than those in Lead and therefore are larger. The machine takes account of these differences when
calculating the imbalance.
Table T9.1 Balancing weights materials
Option Type of balancing weight material Notes
Fe Iron or Zinc This material has been set by default.
Pb Lead
In some countries (such as those of the European Com-
munity), Lead weights are prohibited by law.
By pressing this button, the machine alternates the material type of the balancing weights: if the selected
material is Iron/Zinc, select Lead and vice versa. This selection is maintained even when the machine is
shut-down.
The option relative to the type of material selected will appear on the display for a second.
Note:
if Lead has been selected as material, at every machine start-up, a message indicating the selection of this
material will appear for one second after the initial test. See fi gure F9.2. This signal will not be viewed if Iron/
Zinc is selected as material.