Installation Guide

36 CB66 - CB67 - CB68 Operator’s manual
8.2 Selection of the static imbalance display
To view the static imbalance, press [F+P2] . The machine will show the static imbalance
value on the display as seen in fi gure F8.1 and the LED next to the button lights up.
Fig. F8.1 View of the Static imbalance display enabled. The right display indicates the entity of the
static imbalance.
To return to the dynamic imbalance display, press [F+P2]
again. The LED next to the
button will turn off.
Note:
in some cases, static imbalance is forcibly set by the machine according to the current settings. For example, if the
MOTO Wheel Type programme is enabled and the width set is less than 4.5 inches, the machine will automatically
set the static imbalance display.
8.3 Electromagnetic clamping brake (available only on some machine models)
The electromagnetic clamping brake is useful to block the wheel in any position defi ned by the user and
to simplify some operations such as the application or removal of balancing weights.
If present, the electromagnetic clamping brake is also used in the automatic or manual stopping of the wheel
on imbalance positions described in chapter 8.5 SWI Wheel stop procedure on the positions of imbalance.
To activate the electromagnetic clamping brake, press [P9]
p
p
p
p
p
p
p
p
p
p
p
p
p
p
p
p
p
p
p
p
. To deactivate the electromagnetic
clamping brake, press [P9]
g
again.
The electromagnetic clamping brake is deactivated automatically in the following cases:
• Every time a balancing launch is run;
• Every time a SWI procedure is performed (stop of the wheel on the imbalance positions) at low speed;
• After one minute of continuous activation (to avoid overheating of the brake itself).
The electromagnetic clamping brake can be used manually only in NORMAL mode. It cannot be used in
the SERVICE mode.
If the electromagnetic clamping brake is equipped on the machine but disabled, by pressing [P9]
a triple beep is emitted indicating this condition. To enable the electromagnetic clamping brake, contact
technical support.
8.4 Illuminator (only in some machine models)
The illuminator is quite useful because it allows shedding light on the internal part of the rim which is
normally barely visible, thus making balancing operations easier.