Installation Guide

32 CB66 - CB67 - CB68 Operator’s manual

Note:

This programme can be used with any Programme Type and with any Wheel Type. It can also be used to divide

the static weight into two separate weights (especially useful with wheels for motorbikes).

To use this programme, proceed as follows:

1. Perform the balancing of the wheel without applying the external weight;

2. Press [F+P5]

to run the Hidden Weights programme. If the wheel is balanced on

the external side, the machine will display the message shown in ﬁ gure F 6.2 for about 1 second on

the right display and a triple beep will indicate that the operation is not allowed.

Fig. F6.2 Hidden Weight Programme not possible or chosen position not allowed

3. If there is an imbalance on the external side instead, the machine will display the message shown in

the ﬁ gure. F6.3.

Fig. F6.3 Input of the weight W1 position

Note:

You can exit the “hidden weights” programme at any time by pressing [F+P5] .

4. Rotate the wheel manually until all external imbalance search LEDs light up (see detail [9] of ﬁ gure F1).

5. Rotate the wheel manually until the point where you want to apply the external weight W1 is reached

and press [P1]

to conﬁ rm. The angle formed by W1 and by the initial external weight W must

be less than 120°.

6. If the angle is greater than 120°, the machine will display the message shown in ﬁ gure F6.2 for one

second and will emit a triple beep indicating that another point must be chosen. If the angle instead

is less than 120°, the machine will display the message shown in Fig. F6.4, allowing you to continue

with the next step.