Installation Guide

30 CB66 - CB67 - CB68 Operator’s manual
Fig. F5.3 - “Bring the valve to the 12 o’clock position” message
3. Bring the valve to the 12 o’clock position, mark the valve position on the tyre (see fi gure F5.4);
Fig. F5.4 - Marking of the valve position on the tyre
4. Press [P4]
g
. The message seen in fi gure F5.5 will be displayed;
Fig. F5.5 “Run the launch” message
5. Remove the wheel from the shaft, remove the tyre bead, rotate it so that the mark is at 180° respect
to the valve (see fi gure F5.6);
Fig. F5.6 - Marking the tyre at 180° respect to the valve
6. Remount the wheel on the shaft, erase the mark and run a launch;
7. At the end of the cycle, the message seen in fi gure F5.3 will be displayed. Two options are available:
a) Bring the valve to the 12 o’clock position and press [P4]
p
y
y
y
y
y
y
y
y
y
y
y
to continue. In this case, the
message seen in fi gure F5.7 will be displayed.