Installation Guide

CB66 - CB67 - CB68 Operator's manual 29

The calibration in progress will be cancelled and the balancing results will use the calibration results for

the MOTO Wheel Type previously used. Even in this case, the MOTO Wheel Type and the ALU1 Programme

Type will remain set and the dimensions of the wheel will remain those set automatically by the machine

for this type of calibration.

5. OPTIMISATION

The optimisation programme is used to minimise the amount of balancing weights to be applied on the

rim by opposing the imbalance of the rim to that of the tyre.

Therefore, use this programme when the wheel requires the application of heavy balancing weights.

To access the optimisation programme, proceed as follows:

1. Press [F+P4]

. The display will show the options shown in ﬁ gure F5.1. Press [P4]

or [P5] and choose the option oPt-1- to continue, or the option oPt rEt to

return to the operating programme. Press [F+P4]

to conﬁ rm the chosen option;

Fig. F5.1 Access to the Optimisation programme

Note:

you can exit the calibration procedure at any time by repeatedly pressing [F+P4] .

2. If the wheel’s static imbalance is less than 12 grams, the machine will display the message shown in

Figure F5.2 for a second and then will automatically exit the optimisation programme. If the wheel’s

static imbalance is instead greater than or equal to 12 grams, the message shown in Figure F5.3 will

be displayed;

Fig. F5.2 Optimisation Programme not possible