Installation Guide

CB66 - CB67 - CB68 Operator's manual 27

3. Press [F+P3] . The writing

SER SER

will be displayed (this means that we

have entered the SERVICE mode);

4. Press [P3]

. The writing

CAL CAR

(calibration for auto-vehicle and off-road vehicle

wheels) will be displayed;

5. To select the MOTO (motorbike wheel) calibration type, press [P4]

or [P5] . When

the MOTO calibration type is selected, the machine automatically loads the geometric data of the

motorbike ﬂ ange and automatically sets the MOTO Wheel Type and the ALU1 programme.

6. Press [P3]

to conﬁ rm. The writing

CAL 0

will be displayed;

7. Press [P8]

Start or lower the wheel guard: the machine will run a launch;

8. At the end of the launch, the machine will display the writing

h12 CAL

. Apply the calibration

weight on the internal side as shown in Figure F4.2. The calibration weight is to be applied on the hole

that has the writing “CAL” marked on it;

Fig. F4.2 Application of sample weight on the internal side of the motorcycle ﬂ ange on the shaft (Cal2 phase)

9. Bring the motorcycle ﬂ ange in perfect vertical position with the calibration weight at the top part as

shown in ﬁ gure F4.2 and press the [P8]

Start or lower the wheel guard.

Note: If the position is signiﬁ cantly different from the vertical one, the machine will reject running the

launch by emitting an acoustic error message (triple beep).

If the ﬂ ange for motorbikes is close enough to the vertical position but not perfectly vertical, the machine

will run the launch but at the end of the calibration procedure, all balancing launches will present an

error indicating the angular position of the balancing weights;