Installation Guide

26 CB66 - CB67 - CB68 Operator’s manual

16. ... Calibration is completed: the machine automatically exits the calibration programme and returns to

the NORMAL mode, ready to perform the balancing.

If during machine calibration there are some anomalies, error codes will be displayed (e.g. Err 025). See

chapter 6.1 Error Codes and act accordingly to eliminate the problem and to continue/repeat/cancel the

calibration in progress.

The launches interrupted by pressing [P10] Stop

or by raising the wheel guard may be repeated

by pressing [P8] Start

or by lowering the wheel guard.

4.2.1 How to exit the CAR/SUV Wheel Type calibration

You can exit the ongoing calibration procedure at any time by pressing [F + P3] . The

machine will return to the SERVICE mode displaying the writing SER SER. To return to the NORMALE mode,

press [F+P3]

again.

The calibration procedure in progress will be cancelled and the balancing results will use previous calibration

values.

4.3 Calibration according to the MOTO Wheel Type

Calibration for the MOTO Wheel Type (wheels for motorbikes) is completely separated from the machine

calibration for the CAR/SUV Wheel Type because it takes into account the fact that the machine uses a

special ﬂ ange for motorcycle wheels that slightly alters the balancing of the shaft.

If MOTO Wheel Type calibration has not been carried out and you try to run a balancing launch when the

MOTO Wheel Type is selected, the machine will not run the launch and will display the error code

ERR

031

To calibrate motorbike wheels, proceed as follows:

1. Switch the machine on;

2. Apply the ﬂ ange on the shaft for motorbike wheels as shown in Figure F4.1.

CAL

Fig. F4.1 Application of the motorbike ﬂ ange onto the shaft. Align the writing “Cal” on the ﬂ ange

and on the ﬂ ange for motorbikes