Installation Guide

CB66 - CB67 - CB68 Operator's manual 25

To run the machine calibration, proceed as follows:

1. Start-up the machine;

2. Remove the wheel and any other accessories from the shaft;

3. Press [F+P3]. The writing SER SER will be displayed (this means that we have entered the SERVICE

mode) (service programme);

4. Press [P3]

. The writing CAL CAR (machine calibration for auto-vehicle and light off-road

vehicle wheels);

5. With buttons [P4]

or [P5] , select the CAR (auto-vehicle and light off-road wheels)

or MOT (motorbike wheels) calibration type.

Note:

the calibration for motorbike wheels is described separately in chapter 4.3 Machine calibration for MOTO Wheel Type.

6. Press [P3] . The writing CAL 0 will be displayed;

7. Press [P8]

Start or lower the wheel guard. The machine will run a launch and will show the

writing CAL 1 on the display once completed;

8. Mount the wheel on the shaft and enter its dimensions by pressing the keys [P1]

, [P2]

, [P3] to select the dimensions to edit and keys [P4]

or [P5] to edit the

value. If the dimensions of the wheel were introduced before entering the calibration programme, this

step can be skipped. It is not possible to enter the data with the automatic acquisition system;

9. Press [P8]

Start or lower the wheel guard: the machine will run a launch;

10.Once the launch is completed, manually rotate the wheel until value 50 is seen on the left display.

Apply the 50 g weight at the 12 o’clock position on the internal side of the wheel.

11. Press the button [P8]

Start or lower the wheel guard: the machine will run a launch;

12. Remove the 50 g weight applied on the internal side.

13. Manually rotate the wheel until the value 50 is seen on the right display. Apply the 50 g weight at the

12 o’clock position on the external side of the wheel.

14. Press the button [P8]

Start or lower the wheel guard: the machine will run a launch.

15. If the machine is not equipped with electromagnetic clamping brake, or if this has not been enabled,

the machine switches directly to the next step. If, instead, the machine is equipped with electromagnetic

clamping brake, and if this function has been enabled, once the previous launch is completed, the

machine will run a further series of short launches to calibrate the wheel stop function on the imbalance

position (see chapter 8.5 SWI Wheel stop procedure on the positions of imbalance). Do not raise the wheel

guard or press [P10]

Stop during this phase.