Installation Guide

CB66 - CB67 - CB68 Operator's manual 21

2. Select the plane balancing acquisition mode by pressing [P2] until the writing ACq is viewed

on the left display as shown in ﬁ gure F3.10. When the machine is switched on, the acquisition mode is

set by default ;

Fig. F3.10 - “Balancing planes acquisition enabled” message

3. Extract the Distance/Diameter sensor and place it on the rim that corresponds to the internal plane

chosen to apply the balancing weight. See ﬁ gure F3.7 for the ALS1 Programme Type and ﬁ gure F3.8

for the ALS2 Programme Type;

4. Keep the sensor in the rest position until you hear the acquisition beep. If the sensor is left in the rest position

for a longer time, further acquisition probing of that plane will be run without entailing consequences;

5. Set the Distance/Diameter sensor in the rest position immediately. If you hesitate with this operation,

the machine may detect an incorrect plane: in this case, restore the sensor in rest position and repeat

acquisition procedure;

6. Extract the Distance/Diameter sensor and place it on the rim corresponding to the external plane

chosen to apply the balancing weight. See ﬁ gure F3.9;

7. Keep the sensor in the rest position until you hear the acquisition beep. If the sensor is left in the rest position

for a longer time, further acquisition probing of that plane will be run without entailing consequences;

8. Set the Distance/Diameter sensor in the rest position immediately. If you hesitate with this operation,

the machine may detect an incorrect plane: in this case, restore the sensor in the rest position and

repeat acquisition procedure;

3.3.5.2 Balancing launch

Press [P8] Start or lower the wheel guard to run a balancing launch. Once the launch cycle is

completed, the imbalance values calculated according to the balancing planes chosen will be displayed.

3.3.5.3 Search of the balancing planes

The purpose of the balancing planes search is to ﬁ nd the planes previously chosen by the operator in order

to apply the balancing weights. Proceed as follows:

1. The machine enters SrC 0 mode automaticlly when stop rotation. The left window shows SrC like F3.11.

The window will show the unbalance value of ralted position after short break.

Fig. F3.11 - “Balancing planes search enabled” message

2. Apply the weight shown on the left display (internal weight) on the Distance/Diameter sensor as seen

in ﬁ gure F3.12;