Installation Guide

CB66 - CB67 - CB68 Operator's manual 19

3.3.4 Automatic acquisition of the wheel dimensions for the ALS1 and ALS2

Programme Types

To automatically enter the dimensions of the wheel in the ALS1 and ALS2 Programme types, proceed as follows:

1. Assemble the wheel on the shaft;

2. Extract the Distance/Diameter sensor and place it on the plane chosen as the internal plane. The point

of support differs depending on whether the ALS1 or ALS2 programme has been enabled. See ﬁ gures

F3.7 and F3.8;

3. Wait to hear the long acquisition beep and then set the sensor back to the rest position;

4. Extract the Distance/Diameter sensor and place it on the plane chosen as the external plane. See ﬁ gure

F3.9;

5. Wait to hear the long acquisition beep and then set the sensor back to the rest position;

6. The dimensions of the wheel have been acquired and the values can be displayed and/or modiﬁ ed

by pressing [P1]

for the

di1/di2

values (internal/external plane distance) and [P3]

for the da1/da2values (internal/external diameter plane).

Figure F3.7 - Automatic acquisition of the internal plane distance in the ALS1 Programme Type

Figure F3.8 - Automatic acquisition of the internal plane distance in the ALS2 Programme Type