Installation Guide

18 CB66 - CB67 - CB68 Operator’s manual
3.3.3 Automatic acquisition of the wheel dimensions for the STD and ALU1,2,3,4,5
Programme Types
To introduce the wheel size automatically, proceed as follows:
3.3.3.1 Machines with Width sensor
1. Assemble the wheel on the shaft;
2. Extract both sensors and rest them on the rim as shown in Figure 3.6;
3. Wait to hear the long acquisition beep and then set the sensors back to the rest position. During
acquisition, the distance and diameter values are shown on the display.
Note:
the width is not displayed during automatic acquisition but to verify the newly acquired value, simply press
[P2]
.
It is possible to extract the Width sensor alone and view the width that refers to the last distance acquired
(manually or automatically), but there will be no acquisition in this case. However, if you also extract the
distance/diameter sensor, the display with the width will be removed and the acquisition as described in
point 3 will start.
3.3.3.1 Machines without the Width sensor
1. Assemble the wheel on the shaft;
2. Extract the Distance/Diameter sensor and place it on the rim as shown in Figure F3.6.
3. Wait to hear the long acquisition beep and then set the Distance/Diameter sensor back to the rest
position;
4. Introduce rim width manually. The width of the rim is normally printed on the rim itself. Alternatively,
use the appropriate width measuring gauge.
Figure F3.6 - Automatic data acquisition in the STD, ALU1,2,3,4,5 programmes