Installation Guide

CB66 - CB67 - CB68 Operator's manual 13

3.3.1 Manual entering of the wheel dimensions for the STD and ALU1,2,3,4,5

Programme Types

To introduce the wheel size manually, proceed as follows:

1. Assemble the wheel on the shaft;

2. Extract the distance sensor and place it on the wheel as shown in Figure F3.3.

3. Read the distance value on the graduated scale as shown in ﬁ gure F3.3. The distance value is always

expressed in millimetres;

4. Press [P1]

to modify the distance and then press [P4] or [P5] within

1.5 seconds to enter the read value. If you do not press buttons [P4] or [P5] within this time limit, the

machine will return to the previous display. In this case, you can press [P1]

again to enter

or edit data;

5. Measure the width of the wheel with the special gauge or read the value of the width indicated on the

rim. The value of the width can be in inches or millimetres according to the selected unit of measure.

6. Press [P2]

to modify the width and press [P4]

or [P5] within 1.5

seconds to enter the read value. If either one of these two buttons is not pressed within in this time

frame, the machine will return to the previous screen. In this case, you can press [P2]

again

to enter or edit data;

7. Read the value of the diameter indicated on the rim or tyre. The value of the diameter may be expressed

in inches or millimetres according to the selected unit of measure.

8. Press [P3]

to modify the diameter value and then press [P4] or [P5]

within 1.5 seconds to enter the read value. If either one of these two buttons is not pressed, in this

time frame, the machine will return to the previous screen. In this case, you can press [P3]

again to enter or edit data;

Figure F3.3 - Manual acquisition of wheel dimensions: placing the Distance sensor