Installation Guide

CB66 - CB67 - CB68 Operator's manual 11
GB
MOTO
Motorbikes
Forcibly set the ALU1 Programme
Type
SUV
Off-Road vehicles
Not suitable for balancing wheels
of trucks
Each of these programmes set specifi c values for the measurement of the dimensions of the wheel and the
calculation of imbalances. The particularities of each programme are indicated in the following paragraphs.
To select a specifi c Wheel Type, press repeatedly [P6]
g
until the corresponding LED turns on as
shown in the table T3.2.
3.2.1 CAR wheel type (auto-vehicles)
The selection of the CAR Wheel Type allows the balancing of wheels of auto-vehicles. For off-road vehicles,
it may be appropriate to select the SUV Wheel Type (see paragraph below).
To select the CAR wheel type, press repeatedly [P6]
(pg
until the CAR LED of the Wheel Type group
LED lights up. See table T3.2.
3.2.2 MOTO wheel type (motorbikes)
The selection of the MOTO Wheel Type allows the balancing of wheels of motorbikes.
These wheels need to be mounted on the shaft of a special fl ange. Since the fl ange pushes the wheel away
from the machine, you must also install a special extension for the distance sensor.
To select the MOTO wheel type, press repeatedly [P6]
until the MOTO LED of the Wheel Type
group LED lights up. See table T3.2.
When the MOTO wheel type is enabled, the ALU1 Programme Type is automatically selected and any attempt
to select another type by pressing [P4]
or [P5]
y
y
y
y
yp
p
p
p
p
will be rejected. The point of application
of the weights along the rim section is that of the ALU1 Programme Type and is indicated in fi gure F3.1.
When the MOTO Wheel Type is enabled, you can select the display of dynamic or static imbalance by
pressing [F+P2]
yp
but if the set width of the wheel is less than 114 mm (or 4.5 inches),
the static imbalance value will be always displayed.
To acquire the geometric data of the wheel automatically with the Distance/Diameter and Width sensors,
you must use the same reference points on the rim of the ALU1 Programme Type.
Furthermore, when the MOTO wheel type is enabled, the current distance value is automatically increased
by 150 mm in order to take account of the length of the extension for the Distance sensor.