Installation Guide

2
be made every two years. The bearing cannot be
opened for the test, so insert a screwdriver and check
the sound produced. As the bearing acts as a clamping
support, it is not easy to change or take out the grease.
In addition, the rotation speed is not high for the
machine, so it is not necessary to change the grease. If
you notice an incorrect working or a noisy bearing,
replace the bearing. If the customer confirms that the
bearing has not been replaced, just change the grease,
then disassemble the bearing, open the dust guard ring
and add the grease (XHP103), carrying out these
operations under the guidance of a professional.
Calibrate the machine after replacing the bearing. If the
operation has not been carried out correctly, the
machine precision will be affected, so reposition the
dust guard ring, reassemble the machine and repeat
the adjustment.
Technical safety card for using grease in the wheel
balancer
Mobilgrease XHP
103
NLGI degree
3
Type of thickener
Li-co
mple
x
Colour, appearance
Dark
blue
Penetration on the processed item 2,
ASTM D 217, mm/10
235
Dropping point, °C, ASTM D 2265
280
Viscosity oil base, ASTM D 445, cSt @
40°C
100
Change of penetration consistency,
ASMT D 1831
(established upon the rolling of the
greases), mm/10
10
4 spheres test, impression diam.,
ASTM D 2266, mm
0.5
4 spheres test, welding load, ASTM D
2509, kg
315
Test Timken OK load, ASTM D 2509,
lb
45
Stability of oxidisation bomb method,
ASTM D 942, pressure
drop at 100 hours, kPa
35
Corrosion prevention, ASTM D 1743
Pass
ed
Emcor rust, IP 220, wash away with
acid water
0
Rust protection, IP 220-mod, wash
away with distilled water
0
Corrosion on copper, ASTM D 4048
1A
Resistance to water spray, ASTM D
4049, % spray
15
Wash away with water, ASMT D 1264,
loss (weight%), @ 79°C
5
SCRAPPING
If the machine is to be scrapped, separate all electrical,
electronic, plastic and ferrous components and dispose
of them separately, as provided for by local regulations
in force.
Environment information:
If the machines have the crossed-out bin symbol on
their data plate , the following disposal procedure
must be applied to.
.
This product may contain substances that can be
hazardous to the environment and to human health if it
is not disposed of properly.
Electrical and electronic equipment must never be
disposed of in the usual municipal waste but must be
separately collected for their proper treatment.
The crossed-out bin symbol , placed on the product
and on this page, reminds the user that the product
must be disposed of properly at the end of its life.
Thus, the hazardous consequences that non-specific
treatments of the substances contained in these
products, or improper use of parts of them, may have
on the environment or on human health are prevented.
Furthermore, this helps to recover, recycle and reuse
many of the materials contained in these products.