Installation Guide

7
WHEEL BALANCER ACCESSORY
MAINTENANCE
Warning
The manufacturer will not bear any responsibility if the
problems are caused by the application of the
unoriginal spare parts and accessories.
Warning
Pull out the power plug and secure all the movable
parts are locked before the execution of the
adjustment and maintenance.
Warning
Do not remove or improve any part of the machine.
Caution
Keep the working area clean.
Never use the compressed air /water water spray to
remove the dust and residual on the machine.
Prevent the coming of the dust in the process of the
operation.
Keep the clean of the balance shaft, nut, cone and the
flange. Use the brush rinsed in the neutral solution to
clean these parts.
Carefully operate the cone and flange to avoid the
accident fall and the following damage. Its result is the
influence on the accuracy of the centering. Place the
cone and flange in the condition of dust-proof. If
necessary, use the ethanol to clean.
Make the calibration once per 6months.
LUBRICATION
The only rotating parts of the wheel balancer are the
motor and the balancing shaft, so the bearing of these
components must be checked periodically by the
operator and greased. If the machine is used frequently
(more than two hours per day), check the bearing every
year; if the machine is not used so often, the check can
Standard accessory
Accessory
Description
Quantity
Accessory
Description
Quantity
Cone and
flange disk
One pc
Weight caliper
One pc
pliers
One pc
Thread shaft
One pc
Quick nut
One pc
Standard
weitht
One pc