Installation Guide

2
DISPLAY UNBALANCE VALUE
When the spin ends, the display will display the inner
and outer unbalance
value of the rim. Use your hand to pull the wheel. When
all the positioning lamps light inside and outside light,
the weight adding position will be indicated.
Rotate the wheel, when the left side positioning lamp all
light, at this moment, the highest position is the inner
unbalance position and when the right side positioning
lamp all light, at this moment, the highest position is the
outer unbalance position.
Add the corresponding weight at the unbalance point
and start test again until the balance of the tire.
1. When start the machine, use hand to pull the wheel
to help it start rotation, especially to the relative
bigger tire, to prolong the working life of the motor.
2. Check if there are any mistakes on the dimension.
3. Check if the balance methods meet the
configuration of the rim and select the balancer most
easily to balance.
4. Check if the contract nut tight or not.
5. When the balance ends, remove the tire. Pay
attention to handle it with gentle and avoid knocking the
main shaft. When clipping the weight. Use the hammer
to clip the weight on the rim without too much force. Do
not knock the main shaft hardly to avoid damaging the
sensor. The position to add the weight should be free
from the grease and should be dry.
RESIDUAL UNBALANCE VALUE
DISPLAY
The minimum value of the standard weight is 5g so if
the weight you use is less than 5 g, the wheel balancer
will not display the value and only displays the state of
―00‖. When you need to display the residual unbalance
value, you should press and the display will
immediately display the inside or outside unbalance
value of less than 5g. The maximum residual
unbalance value is 4 g.
BALANCE MODE SELECT
Select the balance mode according to the weight
adding position and the balance mode. Press the mode
switching key to select the balance mode. When
you switch on the machine the machine will automatic
enter into the dynamic balance mode and no need to
select.
Balance mode introduction
Dynamic balanceClip the weight
at the two sides of the rim. It is
dynamic balance mode after
booting up the wheel balancer
which is the default mode. That
means it is common dynamic
balance mode when all the
function indicator not light up.
Static balanceThis mode should
be applied when the weight cannot
be attached at the both sides of the
rim.