Installation Guide
1
Input of the tire parameter
Input the value of Dis(Distance)
Pull the scale to the position to attach the weight on the
rim. Use the press button to
input the data indicated on the scale and at this
moment, the display displays . The
default unit is mm.
Input the value of Br(Breadth)
Use the width caliper to measure the breadth of the rim
and press button to input the
data indicated on the caliper and at this moment, the
display displays . The default unit is inch.
Input the value of DIA (Diameter)
After confirm the diameter, press the press button to
input the value of the diameter and at this moment, it
displays . The default unit is inch.
Unit choice and conversion:
① Br value conversion between inch and
mm:
Under the Br display, the normal displayed unit is inch.
When you need the mm to be the unit displayed, use
this key to realize the unit conversion between inch and
mm.
②Dia value conversion between inch and
mm:
Under the D display, the normal displayed unit is inch.
When you need the mm to be the unit displayed, use
this key to realize the unit conversion between inch and
mm.
③conversion between gram and ounce:
The normal displayed unit is gram (g). When you need
the ounce (Oz ) to be the unit displayed, use
to realize the unit conversion between g and Oz.
Press the wheel balancer start key
, the wheel balancer starts
rotating. A few seconds later, the machine automatically
stops. If the machine is equipped with the protection
cover, you can set up and lower down the protection
cover, machine automatically starts up. You can set
up if the function of the protection cover is open or not.
FIG 13