Installation Guide
8
Positive positioning is the normal
method. It is featured with simple
and quick operation. It is mainly
suitable to the common steel rim
and aluminum alloy rim with small
deformation.
Main shaft Wheel(direction of
the rim installation surface is inside)
cone quick nut
When the deformation of the outside
of the wheel, adopt this method to
positioning to grantee the accurate
positioning of the steel rim inner hole
and main shaft. It is suitable to the
steel rim, especially the thick ALU
rim.
Main shaft tower spring
suitable cone wheel
bowl quick nut
Suitable to the big tire assemble
Main shaft flange disk(fixed
on the main shaft)
wheel cone quick nut
Mount tire
Select the cone adapting to the center hole of the tire
and mount on the wheel balancer following the
indication of the figure.
FIG10
FIG 11
FIG12