Installation Guide

6
C
Outside unbalance
position lamp
I
ALU3 aluminum
mode 3 lamp
D
Parameter display/
outside unbalance value
display
J
Truck tire balance
mode lamp
E
BrDia unit (mm/inch)
conversion lamp
K
Car tire balance
mode lamp
F
STA static mode lamp
L
Unbalance value
(Gr/Oz) lamp
The note to the wiring of the power cable
If the machine adopts the power source, 3ph
380V/220V/etcthe machine will not equip the plug
before out of the factory and it need the customers to
connect the power cable. It needs to test after the
complete of the power cable. If the motor rotates
reversely, the machine will remind the error of reverse.
At this moment, you should power off and change the
positions of any two live wires to change the rotation
direction. In the future operation, you can use normally.
a
b
c
d
e
f i
g j
h
a
Dis input key
f
Program setup key
b
Br input key
g
truck/car mode
conversion key
c
Dia input key
h
Unbalance display key
d
Start press key
i
Gr-Oz mm-inch unit
conversion key
e
Stop/exit key
j
Balance mode
conversion key