Installation Guide

5
*When the weight of the tire exceeds 15kgyou should
use the lift to carry the tire and not by hand to avoid the
injury to the person.
*Before operating the wheel balancer, you must use the
anchor bolt to fix at 3points, or it will produce the
vibration to cause the inaccuracy of the test result,
especially the weight of the tire exceeds 35kg.
*The machine is equipped with protective hood and the
interlock switch. When the hood lower the motor will
automatically start up and the motor will stop when
raise the hood. Please do not remove the hood for your
safety.
*The operator should wear the close-fitting work suit, it
is necessary to line up a good clothing button or pull
pouch hung from belt. The gloves should be the thin
gloves. When operation, cannot wear the sandals and it
is best to wear the insulation shoe.
*When the machine in operation, there should not be
the other electronic equipments of the high-power
equipments to avoid the electromagnetic interference
to the machine-generated, affecting the accuracy of the
test machine.
If the light of the workplace is bad, lighting equipment
shall be ready by you. The ordinary fluorescent or
incandescent lighting is better, it is no need too bright,
the brightness not affecting any operation is
appropriate
2.5)Please pay attention to the following
Do not refit the wheel balancer by yourself.
The rotating main shaft must have the protection to the
bump.
After the dynamic wheel balancer is switched off, it
must be restart after 5seconds.
Do not place too many heavy objects on the wheel
balancer.
If there is any abnormal situations such the sudden
noise, smoke of any other special situation, you must
pull out the power source plug immediately and notify
the service person.
There should be the enough space at the area of the
plug of the wheel balancer to pull out the plug very
easily.
The wheel balancer cannot be used for the operation
not specified in the manual and cannot used to execute
the functions not belonging to the functions of the wheel
balancer.
Display control panel brief
description
A B C
D E F
G H I
J K
L
A
Parameter display/ inside
unbalance value display
G
ALU1 aluminum
mode 1lamp
B
Inside unbalance position
lamp
H
ALU2 aluminum
mode 2 lamp