Installation Guide

4
CPneumatic theory diagram
Operation and operation caution
*Do not install the machine in the area too hot or too
cold and avoid placing the machine near the heater,
cock, air humidity device or the oven.
*Do not place the machine close to the window to avoid
the direct sunlight. If installed by the window, you
should equip the shield to cover the machine such as
curtain.
*Keep the machine from the chemicals such as dust,
ammonia, alcohol, thinner, power and adhesive etc.
*Do not install the machine near the equipments can
produce the vibration and the air compressor.
*In the process of operation, except the operator, any
other person can not close the machine in using.
*Dynamic wheel balancer must use the separate rated
power source and connect with any other electrical
equipment to the socket. If without the reliable earth
power source, you must provide the reliable power
source.
* The input power cable must be firmly fixed.
* If you have to move the wheel balancer, you must
equip the protective device to avoid the damage to the
machine.
Installation area
*The distance between the rear of the wheel balancer
and the wall is more than 80cm and the distance
between the left panel and the wall should be more
than 50cm to secure the perfect ventilation and the limit
of space to the operation and the distance between the
right panel of the case and the wall should be more
than 200cm to make it convenient to mount and
demount the tire and mount the lift device for the tire.
MOUNTING THREAD SHAFT
Before using the machine, you should mount the thread
shaft on the main shaft of the machine. Before install
the thread shaft, use the cotton yarn to clean up the link
between the main shaft and thread shaft and then use
spanner to firmly mount the thread shaft on the main
shaft by following the figure.
1Mpa=l0Bar
1Bar=14.5Psi
1Bar≈1Kg/cm2
50cm
≥80cm
200cm
FIG5
FIG 6