Product Manual

6
Attaching The Overhead Beam and Shut-Off Bar
1. The overhead beam is attached to the extensions at the ends with eight nuts and bolts.
See picture.
2. The cable sheaves must assembled onto the shafts with the spacers supplied as shown
in the picture prior to attaching the overhead channel.
3.To Install the Shut-Off Bar
Attach the shutoff bar and switch housing to the underside of the overhead beam. Attach
single bolt and bar first, then install switch housing.
4. Run electrical cord into the beam and back out of the column using provided bulk
head fittings.
NOTE: NEVER
USE AN IMPACT WRENCH TO TIGHTEN ANCHOR BOLTS!