Product Manual

1. Motor does not run: A. Breaker or fuse blown.

B. Motor thermal overload tripped.

C. Defective UP switch. Replace.

D. Faulty wiring connections. Call

electrician.

E. Check the overhead shut-off bar

operation.

It could be faulty or stuck-thus

holding the switch open.

2. Motor runs but lift will not raise: A. Trash is under check valve. Push

handle down and push the UP button at the

same time. Hold for 15 seconds. This should

flush the system.

B. Remove the check valve cover with

an Allen wrench. Clean the ball and seat and

replace the cover.

C. Oil level low. Oil level should be just

under the vent cap port when the lift is

down.

3.Motor runs but lift picks up partial

load only: A. Faulty relief valve. Replace.

B. Oil is coming out of breather on

cylinder.

C. Seals damaged.

4. Oil blows out of breather: A. Oil reservoir overfilled.

B. Lift lowered too quickly while under

a heavy load.

5. Motor hums and will not run: A. Impeller fan cover is dented in. Take

straighten.

B. Faulty wiring - Call an Electrician.

C. Bad capacitor - Call an Electrician.

D. Low voltage - Call an Electrician.

E. Lift over loaded.

6. Lift jerks up and down: A. Cables are too loose - (See Adjusting

The Equalizer Cables).

B. Air in system - bleed the system.

(See Installation Instructions - Bleeding the

System

TROUBLESHOOTING THE LIFT