Installation Guide

TC-950 & TC-950-WPA

July 2017

Fig. 37

Fig. 38

Fig. 39

Fig. 40

6.2 USING THE LEFT SIDE PRESS ARM

6.2.1 After detaching the tire from the rim according to the instruction of the Chapter 5, you can execute

the following operations.

6.2.2 First, position the claws according to the dimension of the tire and then clamp the rim by the claws

and position the tire press cone roller at the center of the rim (Fig. 37). Push down on the manual valve to

press the rim down until the rim is lower than the surface of the claws. At this moment, you can

immediately lock the rim. Lift up the support arm and place it at the working position and take off the

press cone roller and place it on the support.

6.2.3 Use the press (Fig. 38-1) to press down the tire by sections of the rim that is detached from the tire

and use the brush to spread the lubricant on edge of the lip. Position the demount tool (FIG 40-2) in the

demount position. Place the press beside the demount tool to press down the lip and insert the crowbar

below the demount tool in between the rim and lip (Fig. 39). Then lift up the press and move it to the

position opposite to the demount tool and press the lip into the tire detach groove and then rotate the

crowbar to lift the lip onto the demount tool (Fig. 40). Rotate the turntable to detach the upper lip.