Installation Guide

19
TC-950 & TC-950-WPA
July 2017
Fig. 33
Fig. 34
Fig. 35
Fig. 36
6.1.5 Use the fixed supporting bracket (Fig. 33) to connect the body bracket and the body. Insert the
screw to connect.
6.1.6 Connect the air source hose (Fig. 34-2) using the ‘Y’ Tee fitting to connect the outlet hose and the
other end to connect with the inlet of the assistant pressure adjusting valve (Fig. 34-1).
6.1.7 According to the (Fig. 35), fit the bracket on the body that secures the tool box on the fixed bracket
and then use the lock nut to tighten.
6.1.8 Loosen the nut below the base and turn the screw clockwise until it’s against the ground and is tight
(Fig. 36). Re-install the side panel and tool box that was removed section 6.1.1.
The installation of the Left Side Press Arm assembly is now complete.