Installation Guide

14
TC-950 & TC-950-WPA
July 2017
1. Loosen the tire from the turntable.
2. Connect the inflation hose with the tire’s preinstalled valve stem (Fig. 23)
3. In the process of inflation, you should stop the inflation periodically to confirm the pressure indicated on
the pressure gauge so not to exceed the tire’s pressure as specified by the manufacturer. The pressure
decrease valve equipped in the machine will make the air pressure to not exceed 3.5bar or 51psi. The
customer can obtain different inflation pressures by adjusting the regulator’s pressure according to the
requirement.
4. If the inflation pressures too high, you can press down on the deflation button on the inflation device to
reach the required air pressure.
4.4 Rapid Inflation
If the tubeless tire does not fit securely to the rim, you can first apply ‘rapid inflation’ by using the bead
seating Inflation Jets integrated into the clamps and then use common inflation method:
1. Clamp the wheel and connect the inflation hose.
2. Step down the Inflation Pedal to the lowest position (2) and quickly release the pedal when the tire is
full to the upper position (1) as shown above in Fig 24.
3. Repeat stepping on the Inflation Pedal multiple times to confirm the pressure indicated on the
pressure gauge does not exceeds the pressure specified by the manufacturer.
During this process, you should always ensure the wheel has been tightly clamped!
Explosive Warning!
When inflating, please follow the following instructions:
o Carefully check that the tire and the rim are of the same dimension.
o Check the wear condition of the tire to confirm the tire isn’t damaged before inflation!
When inflating the tire, please be carefully. Keep your hands and body away from the tire.
Fig. 24