Installation Guide

13
TC-950 & TC-950-WPA
July 2017
4.2.1 Clean the dirt and rust from the rim and position on the turntable. Secure rim to turntable using the
clamps.
4.2.2 Spread the lubrication liquid or soap liquid around the lip of tire. Tilt the tire against the rim, keeping
the front end upwards. Press down on the hexangular shaft to move the demount tool arm to contact with
the rim and lock. The left lip above the tail of the demount tool and the right lip will be positioned under
the front end of the demount tool (Fig. 21). Then rotate the turntable clockwise to guide the bottom lip into
the tire detaching slot.
4.2.3 If there is tube, place it in the tire and plug the core and assemble the lip according to the above
mentioned step (Fig. 22).
4.3 INFLATION:
When inflating the tire, please be careful and follow the operational process. Ensure to check the air routing
to see if the air connection is ok. Note: the tire changer is equipped with an inflation pressure gauge to
monitoring the inflation of the tire and the tire’s pressure (Fig. 23).
Fig. 21
Fig. 23
Fig. 22