Installation Guide

Inflating
(Fig16)
This machine is
equipped
with
a
gauge
for
pressure
reading
during
inflation.
1 .Loose the tire from the turntable.
2. Connect the inflator with
the air
valve
on the tire.
(Fig
16)
3.Press the
gun
inflator
slowly
for
several
times. Make
sure the reading on the
gauge
does not exceed the manufacturer's limrt
Inflate
tires with lT system
l.There is
a
pedal
on the
side of the
machine.
This
pedal
has two
positions.
The first
position
is for the inflation for the tire with
tube.
Step
the
pedal
lightly for
several
times
during the inflation, Make sure the reading on the
gauge
does
not exceed the manufacturer's limit.
(Fig.17)
2.The
second
position
is for
the
inflation
for the tubeless tire, step the
pedal
down fully to the
bottom,
and
then make
the
pedal
to the first
position
to continue the inflation.
Make
sure
that the reading
on
gauge
doesn't exceed the manufacturer's limit.
t Fig.'1 7
)
)
Keep
your
hand
and body
away
from
the moving
parts
during
the operation, avoid the
injury.
Make sure
the fire
is
not
damaged
before the inflation, and
fhe
pressu
re
in
the fire
does
not
exceed 3.5 bar.
Transport
Make
sure transportthe
machine with its original
package,
and
place
it
according
to the marks
on the
package.
The
packed
machine should be moved
by means
of a
fork lift truck of suitable
capacity,
insertthe
forks
at the
points
shown in
(Fig.18).
(Fig
18)
,?
i
Electrical
diagram
)Make
surc the machine is connected with
the
ground
beforc the opention.
)The
operation of the elecfiicity must
be done by the autho zed opentors.
)
Make
surc the steady of the extemal
power
supply,
if
the rated
power
is 220v, so as to avoid the damage of the
electric caoacitot.
7