Installation Guide

*Prepare
a water segregator
near the
air-compressor,
to reduce the
go
through the
machine.
(Fis,8)
Instructions for the operation
the air that
amount of the
water
)
Only the trained
person
can do the operation of the
machine.
Demounting
l.Release
all the air
inside
the tire,
2.Remove the balance block
from
the external side of
the rim.
(Fig.10)
Do
the operation as
follow:
l,Place the tire between the bead breaker shoe and
rubber
pad,
and
make the
shoe between
the bead and
the tire,
step on
the
tire control
pedal
(10), (in
Fig2
step
the
pedal
10, and
in Fig3
step the
pedal
3)
to
separate
the bead
from the rim.
(Fis.11)
) Lubricate
the bead
with thick soap solution before demounting the tire, avoid
the damage and
facilitating the
operation.
2,Repeat above steps on the other
parts
of the tire
to
get
the tire separated
thoroughly
from the rim.
3.Set
the
vertical
shaft
in the
working
position,
so that the
mount/demount head is near the
rim. The roller in the
mount/demount head should be 2
mm
from the
rim
to
prevent
scratching
the
rim.
(Fig.12)Turn
the lock lever to
lock
(automatic
machine
use
locking handle 11 to lockthe Fig.3)
(Fig.10)
+
iJofe;
the angle of the
mounUdemount
head is
already calibrated
according to the standard
rim
before delivery.
The
user can
re-calibrate it with hexangular
spanner
for
the overlarge or
over small rim so as nof to damage the tire.
(Fis.12)
{i
(#
(Fig.1
1
)
5