Installation Guide

) The
tire changer
with
electric motor
can't
be used in
explosive
atmospheres,
unless if is
a
proper
version.
Installation for
the completely
automatic machine
Place
the machine
on the chosen
place,
then fix it to the
ground
by
fixing
screw. Lift
the tilting arm, and insert the PU
hose
(G)
into the hole
(Fig.5).(
Do
not bend the hose) Then
take out the
partA
(
shown in Fig.5) from
the accessory box,
unscrewthe
caponthetop
of
partA,insertthepartAintotheholethat
go
through
the main box ofthemachineand
thebottomof the
tilting arm, then
tighten the bolt. Take
out the
part
B
(shown
in
Fig,5) from the
accessory box, unscrew the
spring on one side
of
part
B,
then insert
part
B into the hole that
go
through the
part
D, E,
then screw the spring. Dismount
the
protection
plate
on
the
side of the machine.
Connect the PU hose
(G)
that
go
through
the main box
of
the machine
with the
part
F.
After the
above operation is
finished, mount
the
part
E on the
arm
(Fig.6),
then mount
parts
D,
C,
B,
A, G, F in sequence.
During
the operation,
pay
attention
to the PU hose and
other
parts,
B
C
r.
t-
IP--T
r*
(Fig,6)
(Fis.5)
)
lnsert
the expansion
bolt into
the hole
at the
bottom
of the machine
to
fix
the machine,
or if it is not
steady, it
may
cause noise
and
other
problems.
Maintenance
'.,-
-,:.
r,.
'.
-
The
followin
maintenance
must
be done at least
once eve month.
*Check
the
oil level in
the
air-compressed
cup
periodically.
lf it
needs
to be filled,
you
must
shut off
air
source,
then fill
the
SAE30
oil.
*Clean
and lubricate
all the moving
parts
of the turntable.
(Fig.7)
*Check
all connecting
parts
and bolts
periodically
and tighten
them if necessary.
*Keep
the hexagonal
vertical
axle clean and lubricate
it
periodically.
(Fig
8)
*Check
and
adjust
the tension
of the
driving
belt.
(Fig.9)
(Fig.7)
*Keep
the machine
and the
working
area
clean to
avoid the
dust entering
the moving
parts.
*Lubricate
all the moving
side of the machine
weekly.
)
Only fhe
specialized
technician
can do
the
maintenance.
)
Before
doing
any maintenance,
shut
off
power
supplv
and
air source.
4