Installation Guide

Operation
parts
for completely
automatic machine
(Fig.3)
'1
. Pedal for
tilting
the
mounting
column
2 Pedal for
rotating the
clamping
chuck
3.
Pedal
for
pressing
the tire
4 Tool
box
5.
Pedal
for
expanding the
jaws
6.
Tire
crowbar
7.
Clamping
chuck
8. Jaw
9.
Mount/demount
head
10 Vertical
shaft
11
Lock lever
12.
Horizontal
arm
13 Air
pressure
gauge
14.
Air valve
1
5.
Bead
breaker
shoe
16. Rubber
oad
Warning
stickers and
instruction
of the
machine
Never
place
leg
between the bead
breaker shoe and
and cause injury
of the operator.
Never
olace
hand
on the tire when the demount head
,,\
(Fis
3)
bead
breaker
rubber,
avoid stepping the wrong
pedal
is
on the working
position,
avoid the injury of the
I
I
--i-
-1
A
A
A
A
A
operator.
Never
place
your
hand
between the tire and
gripping
device
when
operate
the rim,
avoid the
injury
of the
operator
The
jaws
should
in
closed
position
but
not in
open
position
when
do the bead break,
avoid
the injury
of
the
operat0r,
The
operator shouid wear the
protection
glasses
when inflate
the tires with the machine with
GT system,
avoid
something blow
into
eyes.
n
/t\
Never
put
hand
between the
rim
and tire when inflate the tire,
avoid the
injury
of
the
operator.
l_f
A
There
should be nobody
behind the tilting
pole,
when
the machine is
on
the working
position
/.\
Installation
for
semi-automatic machine
(Fig.4)
SPACE REQUIRED
When
choose the
place
for installation
be
sure that it
complies with
current safety regulations.
The
semi-automatic tire
changer must
be
connected
to the main
electric
power
supply
and air compressed
system.
lt is
therefore
advisable
to
install
the
machine near
these
power
sources.
The
place
of
installation
must
provide
at least the space shown in figure 4,
so as to allow all
parts
of the machine to be
operated
correctly and without any restriction.
lf
the machine is
installed outside, it must
be
protected
bv a
lean-to.
(
Fig,a
)
3